Accessories
-
-
Choose the product options firstItem #: 1000-6525
Measure Distance and Speed using the teeth on a chain sprocket that is ground driven
-
Choose the product options firstItem #: 1000-6996
- 60 teeth
- 7.375" diameter
- .750" inside hole
- .167 thick
This is for the gear tooth sprocket only.
You can buy the Gear Tooth Sensor Kit Click Here.
-
Item #: 1000-6515
Note: This is for the gear tooth sensor only. You can buy the Gear Tooth Sensor Kit here.
-
Choose the product options firstItem #: 1000-3795^
-Connects Agri-Tronix M3 Planter/Sled Monitors to 12VDC
replacement connect kit [1000-4700]
-12' in length and available with either ring terminals or spring loaded battery clamps
**Not for Digi-Star Scales - the AMP connector pinout is different**
-
Item #: 1000-6625
P/N 1000-6625
* Unbreakable spring lever
* Switch actuates from any direction (360 deg)
* Heavy-Duty Die Cast, sealed, limit switch built for Agricultural use
* Weather Pack 3-pin connector (mating connector P/N 1000-3156)
-
Item #: 1000-0626
Sense
Dimensions M18x1 Connection Cable, 3.00 m
Connector WeatherPack 3-pin
Output function PNP, Normally open (NO) Supply voltage 12.0…30.0 V Mech. installation condition Flush (shielded) Rated operating distance Sn [mm] 8.00 mm ( .315 inch ) -
Item #: 1000-6057
This is a complete Sled Monitor system excluding the consoles.
Easily move your consoles from one pulling sled to another
Simply unscrew 3 connectors on the back of the monitor to move to another sled
Mounting bracket , relay harness, power cable, gear tooth kit all included.
-
Item #: 1000-7575-WF
Watertight, Airtight, and Crush Resistant
Perfect for holding dual sled monitors
-
Item #: 1000-7569-WF
Watertight, Airtight, and Crush Resistant
-
Item #: 1050-2502-5hz
We recommend using only the 5hz model for Tractor Pulling Events.
-
Item #: 1000-7378
This is a replacement Antenna for newer M3s .
Your M3 MUST be Version 4.0 or Higher to use this antenna.This antenna can be used on remote signs but is recommended to use our new high gain antenna.
Click below to view our new High Gain Antenna for remote signs:
High Gain Antenna for remote signs -
Item #: 1000-6673
Power Supply for M3 Sled Monitor Judges stand unit
Power connector - 4-pin amp (2 pins populated)
input - 110vac
output - 12vdc @ 2 amps
-
Item #: 1000-8757k
As of 1/1/22 all remote signs are shipped with this High Gain Antenna.
This antenna eliminate signal transmission problems experienced at some tracks.
These antennas can be added to all remote signs that are equipped with removable external antennas.
Includes: Antenna, 3 ft antenna lead and mounting bracket.
This antenna has13dbi gain, original 6 inch whip antennas have a 6dbi gain.
-
Item #: 1000-8757-1
High Gain antenna that mounts to your Sled Monitor.
Increase signal strength from your sled to your judges monitor for quicker readouts.
Comes with mounting kit
Comes with 10' cable
CONTACT US: +1-317-738-4474