Accessories
-
-
Choose the product options first
Measure Distance and Speed using the teeth on a chain sprocket that is ground driven
-
Choose the product options first
- 60 teeth
- 7.375" diameter
- .750" inside hole
- .167 thick
This is for the gear tooth sprocket only.
You can buy the Gear Tooth Sensor Kit Click Here.
-
Note: This is for the gear tooth sensor only. You can buy the Gear Tooth Sensor Kit here.
-
Choose the product options first
-Connects Agri-Tronix M3 Planter/Sled Monitors to 12VDC
-12' in length and available with either ring terminals or spring loaded battery clamps
-
P/N 1000-6625
* Unbreakable spring lever
* Switch actuates from any direction (360 deg)
* Heavy-Duty sealed limit switch built for Agricultural use
* Weather Pack 3-pin connector (mating connector P/N 1000-3156)
-
Sense
Dimensions M18x1 Connection Cable, 3.00 m
Connector WeatherPack 3-pin
Output function PNP, Normally open (NO) Supply voltage 12.0…30.0 V Mech. installation condition Flush (shielded) Rated operating distance Sn [mm] 8.00 mm ( .315 inch ) -
This is a complete Sled Monitor system excluding the consoles.
Easily move your consoles from one pulling sled to another
Simply unscrew 3 connectors on the back of the monitor to move to another sled
Mounting bracket , relay harness, power cable, gear tooth kit all included.
-
Watertight, Airtight, and Crush Resistant
Perfect for holding dual sled monitors
-
Watertight, Airtight, and Crush Resistant
-
A HUGE Case for hauling most anything!
This is the case included with the 20" Portable Distance and MPH signs.
-
-
-
This is a replacement Antenna for newer M3s and and Remote Displays. Your M3 MUST be Version 4.0 or Higher for this to work.
If you have an older model please call 1-800-445-5058.
CONTACT US: 1-800-445-5058 OR +1-317-738-4474